Signamax 12- to 48-Fiber Low-Profile Optical Fiber Enclosur Instrukcja Użytkownika Pobierz pdf

www.signamax.com

16295 N.W. 13th Avenue • Miami, FL 33169 • 800.446.2377 • 305.944.7710 • Fax: 305.949.4483

SL2M-B 02052009

SL2M

1U/Sliding

Tray Fiber Optic Panel

Section 1

Introduction

Signamax Connectivity Systems single rack-space fiber

optic panel provides a simple approach to managing rack-

terminated fiber optic cables, in an easy to install & access

single-unit panel. The panel uses a slide-out tray design,

with a plexi-glass top cover for ease of inspection and

access. Slack cables are stored within the tray, and the

space between cable spools provides mounting provisions

for splice trays, which can be ordered separately.

1.1 Connector Interface Modules

Connector interface modules can be ordered in ST, SC, SC

Duplex, MT-RJ.and LC interfaces through an authorized

Signamax Connectivity Systems Distributor. (Order

separately). Modules install easily from the panel front, with

push/pull latch retainers, that are integral to all interface

modules.

Section 2

Mounting the Panel

Mount the patch panel in a rack or enclosure, using the 10-

32 screws, provided. Although routing the cables into the

panel, once mounted in the rack, is simple, greater access

to the tray can be obtained by removing the plexi top cover,

by removing the two front screws Shown in Figures 2 & 3.

You'll also want to remove the protective film on the cover,

in-place during shipping, to protect the panel cover during

installation. Be sure when mounting the panel frame, that

the mounting flanges are adjusted outward enough relative

to the mounting screws, so that the sliding tray moves

freely in and out of the frame. After cabling the panel, the

plexi-cover can be slid back into the frame, and the two

screws reinstalled. Once installed in rack, you can begin to

route the cables into the panel and secure them to the

panel tray. The tray is designed to enable the cables to

slide forward and back, when the tray is slid out of the

frame.

Interface Modules figure 1

figure 2

figure 3

Premise Connectivity Systems

1 2

Podsumowanie treści

Strona 1 - SL2M-B 02052009

Strona 2 - Up to 12 splices/tray

Komentarze do niniejszej Instrukcji

Brak uwag

Signamax 12- to 48-Fiber Low-Profile Optical Fiber Enclosur Instrukcja Użytkownika

Przeglądaj online lub pobierz Instrukcja Użytkownika dla Akcesoria komputerowe Signamax 12- to 48-Fiber Low-Profile Optical Fiber Enclosur. Signamax 12- to 48-Fiber Low-Profile Optical Fiber Enclosure User Manual Instrukcja obsługi

Podsumowanie treści

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Akcesoria komputerowe Signamax 12- to 48-Fiber Low-Profile Optical Fiber Enclosur