Signamax Managed Hardened PoE Industrial DIN-rail Mount Swi Instrukcja Użytkownika

SIGNAMAX 065-7909HPOE Industrial Ethernet Managed PoE Switch User Manual Jul 2, 2014 Version: V 1.0

1 Preface 5 To access the switch web management function, open a web-browser and ty

1 Preface 6 VLAN Configures Port-based VLAN and 802.1Q VLAN, as well as GARP. Qo

2System Information 72 System Information The device system information is shown as follows.

3 Advanced Configuration 83 Advanced Configuration IGMP Snooping, GVRP, STP, LACP, LLDP, 802.1X, Re

4 Port Management 94 Port Management You can set port configuration, aggregation, bandwidt

4 Port Management 10 4.2 Port Aggregation Link aggregation means aggregating several links t

4 Port Management 11 Caution:  If LACP (Link Aggregation Control Protocol) is disable

4 Port Management 12 4.2.3 Aggregate Basic Setting LACP determines the dynamic aggregation g

4 Port Management 13 4.3 Port Bandwidth You can configure the egress traffic limit on indivi

4 Port Management 14 Port mirroring refers to the process of copying the packets received or

SIGNAMAX 065-7909HPOE Industrial Ethernet Switch iiRevision History Revision Date Reason for change V1.0 2014.7.2 Initial Rel

4 Port Management 15 4.5 POE POE (Power Over Ethernet) is referred to as a technology by whi

4 Port Management 16 4.5.2 PoE Port settings POE Mode： Two selections: PoE, and shut down.

5 VLAN 175 VLAN The traditional Ethernet is a broadcast network, where all hosts

5 VLAN 18 802.1Q VLAN. 5.2 Port-based VLAN Port-based VLAN technology introdu

5 VLAN 19 5.3 802.1Q VLAN VLAN tags in the packets are necessary for the switch to

5 VLAN 20  Note: Select 802.1Q VLAN from the VLAN Mode in 5.1 Advanced, so tha

5 VLAN 21 so. 5.3.3 802.1Q Port This tab page configures 802.1Q VLAN port paramet

5 VLAN 22 5.4 GARP GARP VLAN registration protocol (GVRP) is an implementation

5 VLAN 23 The Join message and the Leave message are used together to complete the

5 VLAN 24 (namely VLAN 1) in this mode even if you configure the port to permit th

SIGNAMAX 065-7909HPOE Industrial Ethernet Switch iiiTable of Contents 1 Preface ...

6 QoS 256 QoS In data communications, Quality of Service (QoS) is the ability of

6 QoS 26 Port-based Priority：There is 8 priorities from 0 to 7. DSCP：Enable or

6 QoS 27 advantage of WRR queue is that: though the queues are scheduled in orde

6 QoS 28

7 Forwarding 297 Forwarding SIGNAMAX 065-7909HPOE industrial switch has unicast MAC a

7 Forwarding 30 Caution:  The port must be a member of this VLAN.  The port sho

7 Forwarding 31 The advantages of multicast are summarized as follows:  Over unicast

7 Forwarding 32 Caution:  Multicast source maybe doesn’t belong to the multicast

7 Forwarding 33 packets are broadcast to all devices at Layer 2. When IGMP Snooping is

7 Forwarding 34 7.3.2 Route Port On this page, you can configure a port in a specified

SIGNAMAX 065-7909HPOE Industrial Ethernet Switch iv 7.1.2 Dynamic Unicast MAC ...

7 Forwarding 35 be deleted from the router port list. It is in the range of 1 to 1000;

8 Security 368 Security It mainly introduces Management Security, Port Aut

8 Security 37 shared key. 8.2 Port Authentication IEEE 802.1x authentication syst

8 Security 38 send feedbacks (through a RADIUS access-accept packet and an EAP-succe

8 Security 39 access network resources in a restrained way. It enables supplicant sy

8 Security 40 function. In this case, this timer sets the interval to send the multi

8 Security 41 MAC address authentication is port- and MAC address-based authenticat

8 Security 42 8.3.3 Authentication Information This page lists all the MAC authenti

9 LLDP 439 LLDP  Note: Enable LLDP in 3 Advanced Configuration. In a h

9 LLDP 44 Field Description Destination MAC address The MAC address to which th

SIGNAMAX 065-7909HPOE Industrial Ethernet Switch v 12.2 RecoverRing II™ Coupling ...

9 LLDP 45 LLDPDUs encapsulated with the same encapsulation format. So is for the

9 LLDP 46 Caution: The port should not be a member of a trunk group. 9.1.2

9 LLDP 47 and the default value is 4. Tx Delay：The delay period between successiv

9 LLDP 48

10 Statistics 4910 Statistics It shows the following items: 10.1 Port Status

10 Statistics 50 Collision： The number of detected collisions DropPkt： The numbe

10 Statistics 51 This page shows IGMP Snooping multicast group information. 10.6 Li

11 Spanning Tree 5211 Spanning Tree 1. Purpose of STP Spanning tree protocol (ST

11 Spanning Tree 53 For a device A designated bridge is a device that is directly connected

11 Spanning Tree 54 the other links to prune the network into a tree. 11.1 STP  Note: Enab

1 Preface 11 Preface This manual applies to the Signamax 065-7909HPOE industrial swit

11 Spanning Tree 55 11.1.2 STP Information This page lists basic information of Designated

11 Spanning Tree 56 the discarding state and stops forwarding packets (as if it were discon

11 Spanning Tree 57 switch or network segment. Rapid transition to the forwarding state is

12 RecoverRing Configuration 5812 Ring Configuration  Note: Enable RecoverRing II™ in 3 A

12 RecoverRing Configuration 59 As shown in the above figure, there are two rings: ring 1 and

12 RecoverRing Configuration 60 The primary and secondary ports of a transit node have the sam

12 RecoverRing Configuration 61 Coupling Backup. 3. Within the same level ring, more than on

12 RecoverRing Configuration 62 3* HelloTime < =FailTime and 3* FastHelloTime <= FastFai

13 SNMP Manager 6313 SNMP Manager The Simple Network Management Protocol (SNMP) is an

13 SNMP Manager 64 SNMP Agent and MIB (Management Information Base). SNMP Management Statio

1 Preface 2 1.2.2 Features  Complies with IEEE 802.3af standards.  8 10/100BaseT

13 SNMP Manager 65 3.1.2 SNMP User The User can manage the device via the management station

13 SNMP Manager 66 13.2 SNMP Trap Agent use SNMP Trap to send traps to NMS. 13.2.1 Global Tra

13 SNMP Manager 67

14 RMON 6814 RMON Remote Monitoring (RMON) is used to realize the monitoring

14 RMON 69 Broadcastkts: The total number of the received good packets that are dir

14 RMON 70 Drop Events: The total number of events when packets are dropped by the

14 RMON 71 14.2.2 History List On this page, one of the history can be selected to

14 RMON 72 the thresholds at the end of the sampling interval. If the value of this

14 RMON 73 value is less than or equal to this threshold, and the last sample value

14 RMON 74 The event group defines event indexes and controls the generation and not

1 Preface 3 10/100BaseTX Port Port Indicator Status Description Green

15 Administration 7515 Administration 15.1 Language There are two languages: Chinese

15 Administration 76 15.4 SMTP This page sets SMTP configuration. When a pre-defined event

15 Administration 77 Onaccess cold start: Enable or disable to trigger an e-mail alarm when

15 Administration 78 The bottom part of this tab page lists all port events. 15.6 System Lo

15 Administration 79 15.8 Account This page can be used to add a new account. Username, P

15 Administration 80 15.9 TFTP Services Compared with FTP, TFTP (trivial file transfer prot

15 Administration 81 15.9.2 Backup Configuration This page sets a TFTP Server IP and File N

15 Administration 82 15.11 Reset There are two tab pages: Reset and Reset To Default. Reset

16 Logout 8316 Logout Click <Logout> on the left menu to log out from the switch

Appendix A Compatible SFP Module 84Appendix A - Supported MIBs This appendix lists the supported Management Inf

1 Preface 4 0.2A@48VDC（Spport up to 8 ports at 15.4W） Overload Current Protection：P